Microprocessor Interview Preparation Guide
Download PDF
Add New Question

Microprocessor Interview Questions and Answers will guide you about the program-controlled device, which fetches the instructions from memory, decodes and executes the instructions. Most Micro Processor are single- chip devices here you will learn all the aspects of a Microprocessor and its research based interview questions and answers which will be help full for getting a better job.

24 Microprocessor Questions and Answers:

1 :: What is a Microprocessor?

Microprocessor is a program-controlled device, which fetches the instructions from memory, decodes and executes the instructions. Most Micro Processor are single- chip devices.
Post Your Answer

2 :: What are the flags in 8086?

In 8086 Carry flag, Parity flag, Auxiliary carry flag, Zero flag, Overflow flag, Trace flag, Interrupt flag, Direction flag, and Sign flag.
Post Your Answer

3 :: Why crystal is a preferred clock source?

Because of high stability, large Q (Quality Factor) & the frequency that doesn’t drift with aging. Crystal is used as a clock source most of the times.
Post Your Answer

4 :: In 8085 which is called as High order / Low order Register?

Flag is called as Low order register & Accumulator is called as High order Register.
Post Your Answer

5 :: What is Tri-state logic?

Three Logic Levels are used and they are High, Low, High impedance state. The high and low are normal logic levels & high impedance state is electrical open circuit conditions. Tri-state logic has a third line called enable line.
Post Your Answer

6 :: What happens when HLT instruction is executed in processor?

The Micro Processor enters into Halt-State and the buses are tri-stated.
Post Your Answer

7 :: Which Stack is used in 8085?

LIFO (Last In First Out) stack is used in 8085.In this type of Stack the last stored information can be retrieved first
Post Your Answer

8 :: What is Program counter?

Program counter holds the address of either the first byte of the next instruction to be fetched for execution or the address of the next byte of a multi byte instruction, which has not been completely fetched. In both the cases it gets incremented automatically one by one as the instruction bytes get fetched. Also Program register keeps the address of the next instruction
Post Your Answer

9 :: What are the various registers in 8085?

Accumulator register, Temporary register, Instruction register, Stack Pointer, Program Counter are the various registers in 8085
Post Your Answer

10 :: What is 1st / 2nd / 3rd / 4th generation processor?

The processor made of PMOS / NMOS / HMOS / HCMOS technology is called 1st / 2nd / 3rd / 4th generation processor, and it is made up of 4 / 8 / 16 / 32 bits.
Post Your Answer
Add New Question