Production Engineer Question:
Download Questions PDF

Side rake angle of a single point cutting tool is the angle:

A. by which the face of the tool is inclined towards back
B. by which the face of the tool is inclined sideways
C. between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool
D. between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base

Answer:

B. by which the face of the tool is inclined sideways

Download Production Engineer Interview Questions And Answers PDF

Previous QuestionNext Question
If the diameter of the hole is subject to considerable variation, then for locating in jigs and fixtures, the pressure type of locator used is:

A. conical locator
B. cylindrical locator
C. diamond pin locator
D. vee locator
Cemented carbide tool tips are produced by powder metallurgy.

A. True
B. False